Bose 3.2.1 GSX Spécifications télécharger pdf (Page 44)

44

DISASSEMBLY PROCEDURES

4. Tuner PCB Removal

4.1 Perform procedure 2.

4.2 Lift up on the forward edge of the and

slide it toward the front of the console until

the PCB jacks clear the rear panel. Lift the

PCB straight up.

4.3 Unplug the tuner PCB ribbon cable from

J6000 on the main PCB.

Re-assembly Notes:

- Make sure that the RF gasket is in place on

the FM antenna connector when re-install-

ing the PCB assembly.

- Make sure that the FM RF connector is

centered in the opening in the rear panel

before tightening the top cover screws.

5. DVD/CD Drive Removal

5.1 Perform procedure 3.

5.2 Unplug the drive power cable from

J3202 on the main PCB.

5.3 Unplug the ATAPI cable from J3200 on

the main PCB.

5.4 Lift the drive and the drive mounting

bracket out of the console.

Note: The drive mounting bracket is the

plastic bracket that the drive is mounted to

that also goes over the main PCB to support

the tuner PCB.

5.5 Make a note of the distance the front of

the drive overhangs the front edge of the

bracket. You will need to align the new drive

in the same way, within about 1/16” (2mm).

Failure to do this will cause the DVD drive

drawer bezel to not line up properly with the

LCD display bezel on the front of the console

when re-assembled.

5.6 Remove the four screws that secure the

drive to the drive mounting bracket. Remove

the DVD drawer eject pin from the manual

eject hole in the front of the drive. Retain this

pin for the new drive.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 67 68

Commentaires sur ces manuels

Pas de commentaire