Bose Direct / Reflecting 901 Series 4 Manuel d'utilisateur télécharger pdf (Page 12)

IV. Connecting Other Equipment

A. TAPE RECORDERS

Since the Active Equalizer is connected to your integrated

amplifier, preamplifier, or receiver, where the tape recorder is

normally connected, extra jacks are provided on the equalizer

for the connection of a tape recorder. Refer to FIGURE 7 and

follow the next five steps carefully.

1. Turn all power off.

2. Connect the RIGHT channel TAPE IN jack on the equalizer

to the RIGHT or “B" channel OUTPUT jack on the tape

recorder.

3. Similarly, connect the LEFT channel TAPE IN jack on the

equalizer to the LEFT or “A” channel OUTPUT jack of the

tape recorder.

4. Connect the RIGHT channel TAPE OUT jack on the equal

izer to the RIGHT or “B" channel INPUT (or LINE IN) jack

of the recorder.

5. Similarly, connect the LEFT channel TAPE OUT jack on the

equalizer to the LEFT or “A” channel INPUT (or LINE IN)

jack on the recorder.

NOTE: IF YOUR CONTROL AMPLIFIER HAS TWO TAPE

MONITOR CIRCUITS. BE CERTAIN TO CONNECT YOUR

TAPE RECORDER TO THE BOSE ACTIVE EQUALIZER. NOT

TO THE UNUSED TAPE MONITOR ON YOUR RECEIVER.

Installation of the tape recorder is now complete. To play the

tape recorder, simply place the TAPE switch on the 901 Active

Equalizer in the MONITOR position (in).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Bose Direct / Reflecting 901 Series 4 Manuel d'utilisateur Page 12