Bose SL12 Instructions d'exploitation télécharger pdf (Page 8)

YOUR SL2 WIRELESS SURROUND LINK

EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands

To adapt the surround speaker cable for Jewel Cube

speakers

Follow these steps before you connect the provided surround speaker cable to your Jewel

Cube

speakers.

1. Loosen the screws on the Jewel Cube

speaker adapter so you can insert the two-wire

ends into its terminals.

• Insert the plain wire (–) into the plain terminal.

• Insert the red-banded wire (+) into the red terminal.

2. Tighten the screws (Figure 6).

Figure 6

Using the adapter

with a Jewel Cube

speaker

Red terminal

screw

Red band

Jewel Cube

speaker

Adapter

on wire

Using this cable with the adapters attached, follow the steps in “To make the receiver

connections” on page 7. Be sure to match each adapter to the proper speaker, right or left.

What the Status LEDs indicate

On the rear of the SL2 transmitter and receiver, the color of the Status LED indicates how

each unit is functioning. With the power pack plugged in, the LED lights as follows:

• Blinking green: when one unit is trying to link to the other.

• Solid orange: in sleep mode for low power use when there is no audio signal to

communicate.

• Solid green: the receiver and transmitter are communicating with each other.

This green LED stays lit for several minutes after communications cease.

• Blinking red: the SL2 receiver is too hot, or there is a problem with the surround speaker

cable connection between the SL2 receiver and the speakers.

For information on how to deal with a blinking red LED, see “Troubleshooting” on page 9.

00_CatapultOG.book Page 8 Thursday, October 26, 2006 4:07 PM

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Bose SL12 Instructions d'exploitation Page 8