Bose ControlSpace Guide d'installation télécharger pdf (Page 13)

Mounting the CC-16 zone controller

Warning: The CC-16 must be installed in a National Electric Code (NEC) approved,

enclosed electrical wall box.

After setting the DIP switches and connecting the wires, mount the CC-16 zone controller in the

electrical box. Two sets of screws are provided. Use the screws that are appropriate for your

wall-box – the #6 for North American boxes, and the M4 for Japanese, European and Australian

boxes.

CAUTION: Do not overtighten the screws. Overtightening may cause the frame to break.

Mounting

After screwing the frame into the wall box, remove the protective clear film and snap on the

cover. The cover can be removed later using a small flathead screwdriver in the slots on the

sides.

Mounting the CC-16 Zone Controller in a North American 2-gang wall box

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Bose ControlSpace Guide d'installation Page 13